CannaGLAP

Blog

Grow basics · 8 minute read · Updated October 15, 2026

How to germinate cannabis seeds

Short answer. Keep seeds moist, dark and warm, ideally around 70 to 85 F (21 to 29 C), and most fresh seeds show a white root within a few days. Plant the seed, or the sprouted seed root down, about 1/4 to 1/2 inch (0.5 to 1.5 cm) deep in a light, moist mix. Give it light as soon as the shoot breaks the surface, and keep the mix damp but never soggy.

A seed is the one stage where you cannot fix a mistake later. Too cold, too wet or too deep, and it simply never comes up. How warm is the spot where your seeds are sitting right now?

What a seed needs: water, warmth and air

A seed wakes up when it soaks up water. The shell softens, a root (the radicle) pushes out first, and then the shoot follows. To do that it needs three things at once: moisture, warmth and oxygen.

The easiest one to get wrong is the third. A seed sitting in waterlogged mix runs out of air. That is why "wet but not soaked" comes up again and again in this guide.

Temperature has the best data. A University of Kentucky study of industrial hemp seed found the best germination, both the most seeds and the fastest, between about 66 and 86 F (19 to 30 C), with the peak near 85 F (29.6 C). Below that range germination slows, and the calculated floor was about 38 F (3.4 C). The same study's timing model works out to half the seeds of one variety sprouting in roughly a day and a half at 77 F (25 C). Heat is riskier than cold: in a Texas Tech study, germination held steady from 50 to 86 F (10 to 30 C) but dropped by about a fifth or more at 95 F (35 C).

Those were hemp seeds tested in a lab, but they are the same species. In practice, aim for 70 to 85 F (21 to 29 C). On a cold floor or a windowsill in winter, a seedling heat mat set to 70 to 75 F under the tray is the simplest fix; University of Minnesota Extension suggests exactly that range for indoor seedlings.

Three methods, compared

Germination methods
MethodHowProsCons
Direct sowPlant the dry or pre soaked seed straight into its first pot or a starter plugNo handling of the fragile root; no transplant shockYou cannot see what is happening under the surface
Paper towelSeeds between damp paper towels on a plate, covered, somewhere warm and darkYou see the root appear; easy to sort dud seedsThe root can tear when moved; towels dry out fast
Soak firstSeeds in a glass of room temperature water for 12 to 24 hours, then sow or move to a towelSpeeds water uptake, especially for older or hard seedsLeaving them under water much longer can starve them of air

None of these is proven best in controlled trials on drug type cannabis. Most growers combine them: a short soak, then either a paper towel or straight into a starter plug. If you are new, direct sowing into a moist starter plug or small pot is the method with the fewest ways to go wrong, because you never touch the root.

Step by step: the paper towel method

  1. Wash your hands and use a clean plate. Young roots are easy targets for the molds behind damping off.
  2. Dampen two paper towels. Wet them, then squeeze until no water drips. They should feel like a wrung out cloth.
  3. Lay the seeds apart on one towel, cover with the other, and put a second plate upside down on top to hold moisture in.
  4. Keep it warm and dark, around 70 to 85 F. A seedling heat mat with a thermostat is the reliable way; the top of an appliance can get hot enough to cook seeds.
  5. Check twice a day. Re-wet the towel if it starts to dry. Never let the seeds sit in a puddle.
  6. Plant when the root is about 1/4 to 1/2 inch long. Longer roots break more easily and may start to twist.
  7. Handle the seed by the shell, never by the root. Tweezers or a clean fingertip are fine.

Label the plate with the date and the strain. If you are starting more than one strain, sprouts look identical.

Planting depth and the first pot

Make a hole about 1/4 to 1/2 inch (0.5 to 1.5 cm) deep in a moist, light mix. Set a sprouted seed root down. Cover it loosely; do not press the mix hard on top.

For an autoflower, sow straight into its final pot, or move it within the first one to two weeks. One autoflower breeder recommends transplanting 7 to 12 days after sowing and warns against letting seedlings get rootbound. See autoflower vs photoperiod and the pot size guide.

From sprout to seedling: the first two weeks

Most seeds break the surface a few days after planting. Watch for the hook of the stem, then two round seed leaves, called cotyledons. The first true leaves, with jagged edges, follow a few days later.

If a seedling suddenly pinches at the soil line and falls over, that is damping off. It cannot be saved. Remove it, let the mix dry more between waterings, and keep the others warmer.

When a seed will not sprout

Give a seed 7 days in good conditions before you write it off. Then work through the usual causes.

Troubleshooting slow or failed germination
What you seeLikely causeWhat to do
Nothing after a week, seed firmToo cold, or an old seedMove to 75 to 85 F; give old seeds a longer soak
Seed soft, smells or turns darkToo wet, rotDiscard; use less water next time
Root appeared, then stopped and brownedDried out, or root damaged when movedKeep towels moist; plant earlier, handle less
Sprouted but never surfacedPlanted too deep, or mix packed hardPlant 1/4 to 1/2 inch deep in loose mix
Seedling falls over at the soil lineDamping offFresh mix, clean pots, warmer and drier surface

Seed age matters. In a 2004 study of hemp seed, fresh certified seed germinated at about 96%. After three years, seed kept in a refrigerator at 39 to 45 F (4 to 7 C) germinated at about 65%, and seed kept at room temperature only about 46%. Store spare seeds cool, dry and dark in a sealed container, and expect older seeds to need more patience.

How to know it went right

Two weeks after the root first showed, a healthy seedling has a short, sturdy green stem, open seed leaves, and at least one or two sets of true leaves. The leaves are mid green, not yellow and not dark and clawed. The mix is damp below the surface, not wet on top.

Write down the date each seed cracked, the date it surfaced, and the temperature. Those three numbers tell you, next grow, whether your spot is warm enough. Canna GLAP lets you start a plant record from the seed stage and keep a dated photo of each one, private and encrypted on your phone.

From here, the plant moves into veg. The full timeline from this point is in cannabis grow week by week. If the leaves look wrong early, the problem library can help you name it.

Questions growers ask

How long does it take for cannabis seeds to germinate?

Most fresh seeds show a root within a few days at 70 to 85 F; in lab tests on hemp seed at 77 F, half of one variety had sprouted in about a day and a half. Older seeds or cooler spots can take a week or more, so give a seed 7 days in good conditions before giving up on it.

What temperature is best for germinating cannabis seeds?

Around 70 to 85 F (21 to 29 C). A University of Kentucky study of hemp seed found the best results between about 66 and 86 F, while a Texas Tech study saw germination drop at 95 F.

How deep should I plant a cannabis seed?

About 1/4 to 1/2 inch (0.5 to 1.5 cm) deep, root down if it has sprouted, covered loosely with moist mix.

Is the paper towel method better than planting directly?

Not proven either way. Paper towels let you see the root, but it can tear when moved. Direct sowing into a moist plug or pot avoids handling the root and suits beginners.

Should seeds germinate in light or dark?

Germinate in the dark or under cover, then give light as soon as the shoot breaks the surface so the seedling does not stretch.

How should I store cannabis seeds?

Cool, dry and dark in a sealed container. In one hemp seed study, three year old seed kept refrigerated germinated at about 65% versus about 46% at room temperature.

Read next

Sources

Education only, for adults 21+ where home cultivation is legal. Updated October 15, 2026.