CannaGLAP

Blog · Grow tents

Grow tents · 7 minute read · Updated October 15, 2026

What size fan does a grow tent need?

Short answer. Multiply your tent's length, width and height in feet to get its volume, then choose an exhaust fan that can move that volume every 1 to 3 minutes after losing about 25 percent to a carbon filter and ducting. For a 4x4x6.7 ft tent (107 cubic feet), that means a fan rated about 150 to 200 CFM at minimum. Then check heat: a 480 watt light needs about 150 CFM of real airflow to hold the tent within 10°F of the room, which is why most 4x4 tents end up with a 6 inch fan run slow on a speed controller.

An undersized fan does not fail loudly. It fails slowly: a tent that runs a few degrees too warm, humidity that creeps up after lights off, a smell that leaks into the hallway. By the time you notice, the plants have been paying for it for weeks.

What the exhaust fan is really doing

The exhaust fan is the tent's lungs. It does four jobs at once:

So which job is hardest in your space? In a cool basement it is usually humidity. In a warm apartment it is usually heat. Size the fan for the hardest job, and run it slower for the easy ones.

Step 1: work out your tent's volume

Length × width × height, all in feet, gives cubic feet. Use the inside height of the tent.

Volume of common grow tents
TentVolumeCFM to swap the air every 1 minuteEvery 2 minutes
2x2x4 ft16 cu ft168
2x4x6 ft48 cu ft4824
3x3x6 ft54 cu ft5427
4x4x6.7 ft (80 in)107 cu ft10753
5x5x6.7 ft (80 in)167 cu ft16783
4x8x6.7 ft (80 in)213 cu ft213107

These are airflow numbers at the tent, after everything that slows the fan down. The fan you buy has to be rated higher. Steps 3 and 4 show by how much.

Step 2: pick an air exchange rate

Most grow tent guidance lands on one full air exchange every 1 to 3 minutes. Greenhouse engineers use the same scale: UMass Extension sizes summer greenhouse fans for one full air volume per minute, and a Southern Regional Aquaculture Center greenhouse fact sheet gives 1 to 1.5 volumes per minute as the rule of thumb for cooling.

Sizing for 1 minute and running the fan slower when you do not need it gives you both options with one fan.

Step 3: allow for the carbon filter and ducting

The CFM printed on the box is measured with little or nothing attached. Real airflow drops as you add resistance, which engineers call static pressure. Fan makers publish performance charts that list CFM at different static pressures for exactly this reason. In one greenhouse fan example from the SRAC fact sheet, a 36 inch fan rated 10,308 CFM at 0.05 inches of static pressure falls to 9,553 CFM at 0.10 inches, and a tent fan pushing through a carbon filter faces far more resistance than that.

Practical allowances retailers and growers use:

A simple rule: take your target CFM from Step 1 and divide by 0.75. For a 4x4 at one exchange a minute, 107 ÷ 0.75 is about 143 CFM. Add some headroom for a filter that loads up over the grow, and you are shopping for a fan rated about 150 to 200 CFM. Match the carbon filter to the fan's rated CFM and its duct size, not to the smaller number you needed.

Step 4: check the fan against your light's heat

Volume math ignores the biggest load in most tents: the light. Every watt it draws ends up as about 3.41 BTU per hour of heat. HVAC engineers use a standard formula to turn heat into airflow:

CFM = BTU per hour ÷ (1.08 × temperature rise in °F)

The temperature rise is how much warmer the air leaving the tent is than the room air coming in.

Real airflow needed to carry out light heat
Light drawHeatCFM for a 10°F (5.5°C) riseCFM for a 5°F (2.8°C) rise
150 W512 BTU/h4795
300 W1,024 BTU/h95190
480 W1,638 BTU/h152303
650 W2,218 BTU/h205411
1,000 W3,412 BTU/h316632

This assumes all the heat leaves in the exhaust air. In real life the tent walls shed a little too, so treat it as a safe upper estimate. Still, look at the 4x4 row: a 480 watt light needs about 150 CFM of real airflow just to stay 10°F above the room, which is more than the one-minute volume number. Divide by 0.75 for the filter and you want a fan rated around 200 CFM or more.

If your room is already 80°F (27°C), no fan can make the tent cooler than the room. See grow tent too hot for what to do then.

Fan size chart by tent

Suggested exhaust fan by tent size
TentTypical flower lightRated CFM, 10°F rise to 5°F riseFan size
2x2100 to 150 W40 to 1304 inch
2x4200 to 300 W85 to 2554 inch
3x3230 to 335 W95 to 2804 inch, or 6 inch run slow
4x4400 to 600 W170 to 5056 inch
5x5560 to 930 W235 to 7856 inch, or 8 inch in warm rooms
4x8710 to 1,190 W300 to 1,0008 inch

The CFM column is the Step 4 heat number divided by 0.75 for the filter. The low end suits a cool room where a 10°F rise is fine; the high end holds the tent within 5°F of the room. For scale, a common 4 inch inline fan is rated around 200 CFM and a common 6 inch around 400 CFM; AC Infinity lists its 6 inch CLOUDLINE T6 at 425 CFM. Bigger, slower fans are usually the quieter choice, because fan noise climbs steeply with speed. A 6 inch fan turned down is usually quieter than a 4 inch fan at full speed moving the same air.

Give the air a way in

A fan can only pull out as much air as can get in. Most tents use passive intake: open vents low on the tent, often on the side opposite the exhaust, so fresh air sweeps up through the plants.

Greenhouse guidance sizes intake openings at 1.25 to 1.5 times the area of the exhaust fans. For a 6 inch duct (about 28 square inches of opening), that is roughly 35 to 42 square inches of open intake, or two open 6 inch ports. A tent whose walls suck in gently is right. Walls pulled in hard mean the intake is too small and the fan is straining. Our guide to passive vs active intake covers when to add an intake fan.

Inside the tent, add a small clip or oscillating fan or two so leaves move gently. The exhaust swaps the air; the circulation fans stop damp, still pockets forming in the canopy, which is where powdery mildew and bud rot get started.

How to check your fan is the right size

The easiest way to see all of this is a sensor at canopy height, not on the wall. Canna GLAP pairs with common Bluetooth temperature and humidity sensors and sends you an alert when the tent crosses limits you set, so a fan that stalls at 2 a.m. does not go unnoticed until morning.

Questions growers ask

What size inline fan do I need for a 4x4 grow tent?

A 6 inch fan rated around 400 CFM is the usual pick. It covers carbon filter losses and the heat of a 400 to 600 watt light, and runs slow and quiet most of the time on a speed controller.

Is a 4 inch fan enough for a 4x4 tent?

Sometimes, with a small light in a cool room. A 4 inch fan rated near 200 CFM loses about a quarter of that to a carbon filter, which leaves little headroom for a 480 watt light in summer.

How often should air be exchanged in a grow tent?

Once every 1 to 3 minutes. Every 2 minutes is a good default; every minute suits strong lights and warm rooms.

Can a grow tent fan be too big?

Not if it has a speed controller. Without one, an oversized fan can over-dry seedlings and clones and pull the tent walls in hard. Turn it down instead of buying a smaller fan.

Should the exhaust fan run 24 hours a day?

Usually yes, at a lower speed when lights are off. Humidity jumps after lights off, and that is when steady air exchange matters most.

Read next

Sources

Education only, for adults 21+ where home cultivation is legal. Updated October 15, 2026.