CannaGLAP

Blog

Dry and cure · 8 minute read · Updated October 20, 2026

How do you dry and cure cannabis?

Short answer. Dry slowly in the dark at about 59 to 70 F (15 to 21 C) and 50 to 60 percent relative humidity, the range research uses; many home growers aim for 60 F and 60 percent. That usually takes 1 to 2 weeks. Jar the buds when small stems snap instead of bend, fill jars loosely, and open them daily for a week, then weekly, keeping jars near 60 percent. Throw out any bud with fuzz or a musty smell.

Most growers think the work ends at the chop. It does not. The two weeks after harvest decide whether the jar smells like the plant you grew or like cut hay, and they are the easiest two weeks to rush.

Why is slow drying better than fast drying?

A fresh bud is mostly water. Cornell researchers measured hemp flowers at about 77 percent moisture at harvest. Drying has to pull most of that out, and it has to pull it from the center of the bud as well as the surface.

Go too fast and the outside goes crisp while the inside stays wet. Go too hot and you lose the aromatic compounds. A review from the University of Saskatchewan reports that drying temperatures above 104 F (40 C) significantly reduced terpene content in hemp buds, and one study it summarizes saw terpene retention fall sharply as drying temperature rose from room temperature toward 194 F (90 C).

So the goal is not speed. It is an even, steady loss of water from the whole bud. When did you last check the humidity right next to your hanging branches, not across the room?

What temperature and humidity should a drying room be?

The published numbers cluster tightly:

Drying conditions in the research
SourceTemperatureRelative humidity
Oregon State University Extension (slow drying)64 to 70 F (18 to 21 C)50 to 55 percent
University of Saskatchewan review (common practice)64 to 70 F (18 to 21 C)50 to 55 percent
Cornell study (conventional drying)59 to 68 F (15 to 20 C)50 to 60 percent

Many home growers aim for 60 F and 60 percent, which sits at the cool, slightly humid end of that range. Our dry and cure guide uses it.

Three more rules matter as much as the numbers:

How many days does cannabis take to dry?

Plan on 1 to 2 weeks. The Cornell team describes conventional indoor drying, hanging whole plants or drying trimmed buds on trays, as usually taking 1 to 2 weeks. In their own test, buds dried at room temperature, about 77 F (25 C), took about one week.

Hanging whole branches is slower than racks. The same paper explains why: as a whole plant dries, the outer leaves droop and wrap around the inner buds, which slows drying in the middle and gives microbes a place to grow. If your room runs humid, trim the big fan leaves first and space branches so they do not touch.

If everything feels dry in 3 or 4 days, the room was too warm or too dry. It is still usable. Slow it down next time.

How do you know buds are dry enough to jar?

Growers use the stem snap test, a hands-on check rather than a lab measurement:

  1. Pick a small stem, about the thickness of a match, from the densest bud on the branch.
  2. Bend it. If it folds and stays bendy, there is still water in the buds. Wait a day.
  3. If it snaps with a clean crack, the buds are ready for jars.

Thick main stems may still bend a little. Judge by the small ones. The bud should feel dry on the outside and a little springy when you squeeze it gently. Crumbly means it went too far. Spongy means not yet.

Commercial dryers measure water activity instead of snapping stems. Oregon State gives a storage target of water activity below 0.65. Home meters for that are not common, which is why the jar hygrometer below does the same job for most growers.

How do you jar and burp cannabis?

Curing is the slow part after drying, when moisture left deep in the buds evens out with the surface. Use airtight glass jars. The Cornell study cured dried hemp in sealed glass jars and in mylar bags for 3 weeks in the dark, and the jars ended with slightly lower yeast and mold counts than the bags, though the difference was not statistically significant.

  1. Fill each jar about three quarters full, loosely. Do not pack it.
  2. Put a small hygrometer in at least one jar per batch.
  3. Store the jars somewhere cool, dark and steady.
  4. Check the hygrometer after 12 to 24 hours. A reading that climbs means the buds went in too wet.

Burping means opening the jar to swap damp air for fresh. There is no research schedule for it, so this is common grower practice:

A typical burping routine
WhenHow often
Week 1Open daily for 10 to 15 minutes
Weeks 2 to 4Open weekly, sniff and read the hygrometer
After thatA quick weekly check while humidity holds steady

If a jar reads high, go back to daily opening for that jar, or take the buds out and let them dry another day.

What humidity should the jar be, and do humidity packs help?

Research on curing is thin, and both Oregon State and the Saskatchewan review say so. The one condition both cite comes from a study that cured at 64 F (18 C) and 60 percent relative humidity for 2 weeks, with the lid opened after the first 6 hours. That is why 60 percent, give or take a couple of points, is the common jar target.

Two-way humidity packs hold a sealed jar near a set humidity. Use one only when the jar already reads close to target. A pack is for keeping a good jar steady, not for rescuing wet buds. If the jar reads well above target, the fix is more drying time outside the jar.

Store the jars long term somewhere cool, dark and dry. For the storage room itself, Oregon State suggests about 64 F (18 C) with relative humidity of 45 to 55 percent.

How long should you cure cannabis?

The studies that exist ran 2 to 3 weeks: 2 weeks in the study both reviews cite, 3 weeks in the Cornell jar test. Many growers keep curing for a month or longer and believe the aroma keeps improving. That is a belief from experience, not something the research has measured.

What the research did measure is less exciting and more useful. In the Cornell study, curing did not significantly change total cannabinoid content, and moisture inside the containers shifted by a few percent depending on how dry the buds went in. In other words, the jar mostly finishes the drying evenly. It does not rescue a bad dry.

What does mold look like during drying and curing?

Wet, dense buds in still air are where mold starts. Simon Fraser University researchers found Botrytis, Penicillium and Fusarium bud rots on cannabis flowers, and showed that these fungi could brown and decay buds kept in high humidity. Cornell notes that buds can pick up Aspergillus after harvest, which may produce toxins that are a safety concern.

Check every jar and hanging branch for:

If you find it, remove that bud and anything touching it, and do not use it. Then fix the cause: more airflow, lower humidity, or buds that went into jars too early. Our bud rot guide covers what it looks like on the plant before harvest, which is the best time to catch it.

Keep notes on every dry

Write down the harvest date, room temperature and humidity each day, the day stems snapped, and the jar readings for the first week. After one or two harvests you will know exactly how your room behaves. Canna GLAP lets you track drying and curing jars after harvest in your private grow journal, and how to keep a grow journal covers what else is worth logging.

Questions growers ask

What is the best temperature and humidity for drying cannabis?

Research and extension sources use about 59 to 70 F (15 to 21 C) and 50 to 60 percent relative humidity, in the dark, with gentle air movement. Many home growers aim for 60 F and 60 percent.

How long does it take to dry cannabis?

Usually 1 to 2 weeks. Whole hanging branches dry more slowly than trimmed buds on racks. Drying in 3 or 4 days usually means the room was too warm or too dry.

How often should I burp my jars?

A common routine is daily for 10 to 15 minutes in the first week, then weekly. There is no research schedule for burping, so let a hygrometer in the jar guide you.

Can I use a humidity pack in wet buds?

No. A humidity pack keeps a jar steady once it is near target. If the jar reads well above about 60 percent, take the buds out and dry them longer.

Is it safe to cut the moldy part off a bud?

Throw the whole bud away, along with anything it touched. Mold usually starts inside dense buds before you can see it on the surface.

Read next

Sources

Education only, for adults 21+ where home cultivation is legal. Updated October 20, 2026.